BH ULTIMATE 29ER 9.9
NEW ULTIMATE GENERATION
29” & 27.5"
Developed for the BH Suntour KMC team and the serious biker. It has an aggressive, very lightweight frame, made from high quality carbon fibre.
The BH BIKES R&D team have wanted to provide a new philosophy to the Ultimate 29" frame. The longer top tube, shorter stem and advanced steering angle, provides the cyclist the same virtual position on the bicycle but with a more aggressive sensation and outstanding improvement in descents. The new geometry provides the biker with a greater sensation of trust, stability in the ride especially in technical areas. The rear stays are wider to guarantee maximum rigidity of the frame but with very narrow transversal section also to give maximum lateral rigidity.
New Ultimate 29”
The new Ultimate 290" frame has been developed for the professional cyclist and especially for the BH Suntour KMC team. It has an aggressive frame, very lightweight, and made from high quality carbon. The BH BIKES R&D team have wanted to provide a new philosophy to the Ultimate 29" frame, the longer upper tube, shorter stem and advanced steering angle provides the cyclist the same virtual position on the bicycle but with a more aggressive sensation and outstanding improvement in descents. The new geometrics provide the cyclist with a greater sensation of trust, stability in the ride and in technical areas. The rear stays are wider to guarantee maximum rigidity of the frame but with very narrow transversal section guaranteeing maximum lateral rigidity. It incorporates a 31.6 mm seatpost for lighter weight of the frame and is prepared for incorporating a telescopic seatpost.
HCIM (Hollow Core Internal Moulding)
The Ultimate frame has been built incorporating HCIM moulding technology applied to high performance road frames. The special disposition of the carbon, the resin and the high pressure applied inside the mould avoid irregular pressures and imperfections and allows building a lighter weight, rigid bicycle with the best global performance. The steering tube and the bearings are made from 100% carbon.
Cable guiding inside the frame SHIMANO D12 INTEGRATED INTO THE VERTICAL TUBE
Just like in the road range, cable guides are used for the interior cabling and this is all well integrated, clean, protected inside the frame, and avoids the use of a sleeve that increases the weight of the frame. The new Shimano D12 system is integrated at the lower part of the vertical tube in the bottom bracket. This new system designed by BH integrates the D12 with a simple clip inside the tube.
REAR WHEEL AXLE 142 x 12 Better transmission, better stability
The rear axle uses the Q12 - 142 x 12 system, which increases torsion rigidity by 30% over the 135 x 9 system.
Press Fit 92 mm bottom bracket
The Press Fit 92 bottom bracket with 92 mm width, manages to increase torsion rigidity, reduce the thickness of the walls, and increase the cross section of the diagonal tubes.
Evo Brake Mount
The stays house the Evo Brake Mount system that is located in the rear stay of the frame and with optimal slope angle to reduce braking vibration.
Рама: ULTIMATE 29er CARBON
Вилка: Rock Shox RS1 RL Air
Манетки: Shimano XTR Di2
Тормоза: Shimano XT
Задний переключатель скоростей: Shimano XTR Di2
Передний переключатель скоростей: Shimano XTR Di2
Кассета: Shimano XTR 11-40
Система шатунов: Shimano XTR Di2
Цепь: Shimano XTR
Вынос: BH EVO
Руль: EVO CARBON
Подседельный штырь: BH EVO
Седло: PROLOGO X8
Рулевая чашка: INTEGRATED
Колеса: DT Swiss XRC1200
Покрышки: MICHELIN WILD RACE'R 2.10
Зажим: BH Ultimate
Вес: 9.5 KG.